[   18.753534] ip_tables: (C) 2000-2006 Netfilter Core Team
[   19.365426] dcdbas dcdbas: Dell Systems Management Base Driver (version 5.6.0-3.2)
[   19.443053] dell-wmi: No known WMI GUID found
[   19.563914] shpchp: Standard Hot Plug PCI Controller Driver version: 0.4
[   19.568471] intel_rng: FWH not detected
[   19.798266] yenta_cardbus 0000:01:01.0: CardBus bridge found [1028:0139]
[   19.798290] yenta_cardbus 0000:01:01.0: Using CSCINT to route CSC interrupts to PCI
[   19.798293] yenta_cardbus 0000:01:01.0: Routing CardBus interrupts to PCI
[   19.798300] yenta_cardbus 0000:01:01.0: TI: mfunc 0x012c1202, devctl 0x64
[   20.034731] yenta_cardbus 0000:01:01.0: ISA IRQ mask 0x04c8, PCI irq 11
[   20.034738] yenta_cardbus 0000:01:01.0: Socket status: 30000820
[   20.034744] pci_bus 0000:01: Raising subordinate bus# of parent bus (#01) from #01 to #05
[   20.034758] yenta_cardbus 0000:01:01.0: pcmcia: parent PCI bridge I/O window: 0xe000 - 0xefff
[   20.034763] pcmcia_socket pcmcia_socket0: cs: IO port probe 0xe000-0xefff: clean.
[   20.035454] yenta_cardbus 0000:01:01.0: pcmcia: parent PCI bridge Memory window: 0xfc000000 - 0xfdffffff
[   20.035459] yenta_cardbus 0000:01:01.0: pcmcia: parent PCI bridge Memory window: 0x20000000 - 0x29ffffff
[   20.035713] yenta_cardbus 0000:01:01.1: CardBus bridge found [1028:0139]
[   20.036122] parport_pc 00:0c: reported by Plug and Play ACPI
[   20.036173] parport0: PC-style at 0x378 (0x778), irq 7, dma 1 [PCSPP,TRISTATE,COMPAT,ECP,DMA]
[   20.048393] lp: driver loaded but no devices found
[   20.132270] lp0: using parport0 (interrupt-driven).
[   20.160469] yenta_cardbus 0000:01:01.1: ISA IRQ mask 0x0448, PCI irq 11
[   20.160476] yenta_cardbus 0000:01:01.1: Socket status: 30000047
[   20.160482] pci_bus 0000:01: Raising subordinate bus# of parent bus (#01) from #05 to #09
[   20.160497] yenta_cardbus 0000:01:01.1: pcmcia: parent PCI bridge I/O window: 0xe000 - 0xefff
[   20.160502] pcmcia_socket pcmcia_socket1: cs: IO port probe 0xe000-0xefff: clean.
[   20.161216] yenta_cardbus 0000:01:01.1: pcmcia: parent PCI bridge Memory window: 0xfc000000 - 0xfdffffff
[   20.161221] yenta_cardbus 0000:01:01.1: pcmcia: parent PCI bridge Memory window: 0x20000000 - 0x29ffffff
[   20.251312] ppdev: user-space parallel port driver
[   20.341763] pcmcia_socket pcmcia_socket1: cs: IO port probe 0x100-0x3af: clean.
[   20.342660] pcmcia_socket pcmcia_socket1: cs: IO port probe 0x3e0-0x4ff: clean.
[   20.343033] pcmcia_socket pcmcia_socket1: cs: IO port probe 0x820-0x8ff: clean.
[   20.343097] pcmcia_socket pcmcia_socket1: cs: IO port probe 0xc00-0xcf7: clean.
[   20.343586] pcmcia_socket pcmcia_socket1: cs: IO port probe 0xa00-0xaff: clean.
[   20.361322] input: DualPoint Stick as /devices/platform/i8042/serio1/input/input7
[   20.386317] input: AlpsPS/2 ALPS DualPoint TouchPad as /devices/platform/i8042/serio1/input/input8
[   20.521507] Intel ICH 0000:00:1f.5: PCI INT B -> Link[LNKB] -> GSI 5 (level, low) -> IRQ 5
[   20.521555] Intel ICH 0000:00:1f.5: setting latency timer to 64
[   20.668047] pcmcia_socket pcmcia_socket0: pccard: CardBus card inserted into slot 0
[   20.668099] pci 0000:02:00.0: reg 10 32bit mmio: [0xffff8000-0xffffffff]
[   20.920164] cfg80211: Calling CRDA to update world regulatory domain
[   20.926286] pcmcia_socket pcmcia_socket0: cs: IO port probe 0x100-0x3af: clean.
[   20.927138] pcmcia_socket pcmcia_socket0: cs: IO port probe 0x3e0-0x4ff: clean.
[   20.927510] pcmcia_socket pcmcia_socket0: cs: IO port probe 0x820-0x8ff: clean.
[   20.927575] pcmcia_socket pcmcia_socket0: cs: IO port probe 0xc00-0xcf7: clean.
[   20.928301] pcmcia_socket pcmcia_socket0: cs: IO port probe 0xa00-0xaff: clean.
[   21.287100] cfg80211: World regulatory domain updated:
[   21.287107] 	(start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp)
[   21.287111] 	(2402000 KHz - 2472000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
[   21.287116] 	(2457000 KHz - 2482000 KHz @ 20000 KHz), (300 mBi, 2000 mBm)
[   21.287120] 	(2474000 KHz - 2494000 KHz @ 20000 KHz), (300 mBi, 2000 mBm)
[   21.287124] 	(5170000 KHz - 5250000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
[   21.287128] 	(5735000 KHz - 5835000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
[   21.348331] intel8x0_measure_ac97_clock: measured 55687 usecs (2683 samples)
[   21.348337] intel8x0: clocking to 48000
[   21.676995] rt61pci 0000:02:00.0: enabling device (0000 -> 0002)
[   21.677014] rt61pci 0000:02:00.0: PCI INT A -> Link[LNKD] -> GSI 11 (level, low) -> IRQ 11
[   21.677024] rt61pci 0000:02:00.0: setting latency timer to 64
[   21.751423] phy0: Selected rate control algorithm 'minstrel'
[   21.753392] Registered led device: rt61pci-phy0::radio
[   21.753417] Registered led device: rt61pci-phy0::assoc
[   21.773223] udev: renamed network interface wlan0 to wlan1
[   26.212034] Clocksource tsc unstable (delta = -68897770 ns)
[   32.017502] rt61pci 0000:02:00.0: firmware: requesting rt2661.bin
[   32.356279] ADDRCONF(NETDEV_UP): wlan1: link is not ready
[   33.181238] [drm] DAC-6: set mode 640x480 0
[   33.690110] [drm] DAC-6: set mode 640x480 0
[   34.326175] [drm] DAC-6: set mode 640x480 0
[   34.846274] [drm] DAC-6: set mode 640x480 0
[   40.985709] tg3 0000:01:00.0: firmware: requesting tigon/tg3_tso5.bin
[   41.048979] tg3 0000:01:00.0: PME# disabled
[   41.397590] ADDRCONF(NETDEV_UP): eth0: link is not ready
[   41.862186] [drm] DAC-6: set mode 640x480 0
[   42.360000] [drm] DAC-6: set mode 640x480 0
[   42.993174] [drm] DAC-6: set mode 640x480 0
[   43.498784] [drm] DAC-6: set mode 640x480 0
[   44.172183] [drm] DAC-6: set mode 640x480 0
[   44.671778] [drm] DAC-6: set mode 640x480 0
[   47.984430] tg3 0000:01:00.0: PME# enabled
[   48.006449] tg3 0000:01:00.0: PME# disabled
[   48.367454] ADDRCONF(NETDEV_UP): eth0: link is not ready
[   48.504200] ADDRCONF(NETDEV_UP): wlan1: link is not ready
[   50.464105] wlan1: authenticate with AP 00:16:38:cd:a5:37
[   50.465593] wlan1: authenticated
[   50.465601] wlan1: associate with AP 00:16:38:cd:a5:37
[   50.469065] wlan1: RX AssocResp from 00:16:38:cd:a5:37 (capab=0x411 status=0 aid=1)
[   50.469076] wlan1: associated
[   50.470506] ADDRCONF(NETDEV_CHANGE): wlan1: link becomes ready
[   60.512042] wlan1: no IPv6 routers present
[   76.999597] [drm] DAC-6: set mode 640x480 0
[   77.497175] [drm] DAC-6: set mode 640x480 0
[   78.190971] [drm] DAC-6: set mode 640x480 0
[   78.695148] [drm] DAC-6: set mode 640x480 0
[   79.335372] [drm] DAC-6: set mode 640x480 0
[   79.863833] [drm] DAC-6: set mode 640x480 0
[  647.621540] wlan1: deauthenticated (Reason: 7)
[  648.620281] wlan1: direct probe to AP 00:16:38:cd:a5:37 try 1
[  648.820288] wlan1: direct probe to AP 00:16:38:cd:a5:37 try 2
[  649.020285] wlan1: direct probe to AP 00:16:38:cd:a5:37 try 3
[  649.022330] wlan1 direct probe responded
[  649.022339] wlan1: authenticate with AP 00:16:38:cd:a5:37
[  649.026001] wlan1: authenticated
[  649.026010] wlan1: associate with AP 00:16:38:cd:a5:37
[  649.028288] wlan1: RX ReassocResp from 00:16:38:cd:a5:37 (capab=0x411 status=0 aid=1)
[  649.028298] wlan1: associated